Brandt CE3020 Guide D'installation & D'utilisation page 34

Reversing the direction the doors open
11. The upper left-hand hinge L is placed inside the
plinth (R6). Remove it and inset it into the housing on
the left on the control panel M . Fasten it with the
two screws (R7).
12. Insert the covers N and fasten them onto the control
panel (R7).
13. So as not to lose the top right-hand hinge, which you
may need later, store it in the housing in the plinth
(R6) .
14. Remove the hole covers O on the left-hand side of
the freezer's door (R8).
15. Unscrew the metal door stop P on the right-hand
side of the refrigerator's door, turn it over and screw
it to the left-hand side of the freezer's door, aligning
the hole in the plate with the one in the door ( R8).
Unscrew the metal door stop P on the right-hand
side of the freezer's door, turn it over and screw it to
the left-hand side of the refrigerator's door, aligning
the hole in the plate with the one in the door (R8).
16. Insert the hole cover O , previously placed on the
left-hand side of the freezer's door on the right-hand
side of the same door (R8).
17. Insert the refrigerator's door in the top hinge (R9).
18. Insert the middle hinge and screw it in place, chec-
king that the plastic distance pieces are correctly in-
serted on the pin (R9).
19. Insert the freezer's door into the middle hinge (R9).
20. Insert the bottom hinge into the freezer's door, chec-
king that the plastic distance piece is correctly inser-
ted on the pin between the hinge and the door.
Screw the hinge in place. (R9).
21. Re-install the plinth.
22. Insert the upper covers .
23. Return the appliance to vertical position .
Wait two hours before restarting your refrige-
rator.
L
N
O
34
EN
drawing R6
drawing R7
M
N
drawing R8
drawing R9
P