dji DATALINK PRO Guide De Démarrage Rapide page 6

Installation and Connection
The following uses the DATALINK PRO 900, DJI Matrice 600, D-RTK and
DJI Intelligent Flight Battery to illustrate a typical installation and connection.
1. Attach the Base Station antenna. Place the Base Station on the D-RTK
Ground System's base board, and then fix it with a screw (included with
the D-RTK product). Then connect the Base Station and the D-RTK
Ground System via an 8-pin cable.
2. Install the Mobile Station to the DJI Matrice 600 with double-sided tape.
Attach the antennas to the Mobile Station and fix them to the frame
arms with two clips. Then connect the Mobile Station and the D-RTK Air
System via an 8-pin cable.
•
Refer to the "D-RTK User Manual" for details if using the D-RTK.
Usage
Use the DATALINK PRO in an open environment free from radio interference.
The DATALINK PRO can work in Full Duplex Mode and Broadcast Mode as
described below:
1. Full Duplex Mode: Toggle the 4-position switch to the UART_SW1,
CAN_SW2 or USB_SW3 position. This is useful for point-to-point
communications.
2. Broadcast Mode: Toggle the 4-position switch to the UART_SW1, CAN_
SW2 or USB_SW3 position. This is useful for point to multi-point (up to
32) transmissions.
© 2017 DJI All Rights Reserved.
4