Master Forge MFY784CDP Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY INFORMATION
• Do not use the smoker if the burner fails to light or fails to remain lit. Under such conditions, gas
should be turned off and the fuel cylinder should be disconnected.
• Use in high wind conditions that result in poor burner operation such as blowing out and flaring should
be avoided. If repositioning the appliance does not improve operation under such wind conditions,
the appliance should be turned off.
• Install the smoker with the hose regulator assembly extended the full length of the hose (24 in. minimum)
directly away from the appliance. When so configured, placement results in maximum tank to smoker
distance. When the smoker is operated, the hose/regulator and gas tank should be perpendicular to
wind direction. Placing tank closer than 24 in. to the smoker can overheat the tank and cause release
of propane through relief openings and can result in tank fire or explosion.
• Read and follow all warnings and instructions before assembling and using the appliance.
• Follow all warnings and instructions when using the appliance.
NOTE: The installation must confirm with local codes or, in the absence of local codes, with either
the National Fuel Gas Code, ANSI Z 223.1/NFPA 54, Natural Gas and Propane Installation Code,
CSA B149.1, or Propane Storage and Handling Code, B149.2, or the Standard for Recreational
Vehicles, ANSI A 119.2/ NFPA 1192, and CSA Z240 RV Series, Recreational Vehicle Code,as
applicable.
The electronic ignition requires 1 "AAA" alkaline battery, which is included.
DO NOT mix old and new batteries.
DO NOT mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel-Cadmium) batteries.
DO NOT dispose of batteries in fire. Improper disposal may cause batteries to leak or explode.
WARNING
5

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour Master Forge MFY784CDP

Table des Matières