Pre-Operation - Mi-T-M Corporation 2 Honda WTP-S02-1MGH Mode D'emploi

CHECK ENGINE OIL
NOTE: All units are shipped without engine oil. Refer to engine manual to fill.
1. Place unit on level surface.
2. Remove oil filler cap/dipstick (A) and wipe it clean.
3. Insert filler cap/dipstick into oil filler neck, but DO NOT screw it in.
4. Remove dipstick. Proper oil level is at midpoint of dipstick (A). Add oil if necessary
to bring oil level to top of threads (B).
5. Install and tighten cap.
A
GASOLINE ENGINE OIL
Use oil viscosity based on the expected air temperature
range during the period between oil changes.
Other oils may be used if they meet one or more of the
following:
• API Service Classification SH
• API Service Classification SG
• CCMC Specification G4
• CCMC Specification G5
BEFORE USE
1. Engine is shipped without oil. Refer to engine manual
for proper oil specifications.
WARNING FLAMMABLE! AVOID FIRE WHEN REFUEL OR MAINTENANCE.
CAUTION FLAMMABLE! DO NOT SMOKE WHEN MIXING FUEL AND REFUEL
NEAR OPEN FIRE.
ANY FUEL SPILLAGE MUST BE CLEANED COMPLETELY BEFORE
STARTING THE ENGINE.
STOP ENGINE AND WAIT UNTIL THE ENGINE HAS COOLED DOWN
BEFORE REFUELING.
DO NOT USE OLD FUEL OVER 30 DAYS. FUEL SHOULD BE CLEAN
AND FRESH. FUEL AROUND THE BOTTOM OF DRUM CONTAINS DIRT,
IMPURITIES AND WATER. UNUSED FUEL IN TANK (IF KEPT MORE
Semi-Trash Pump Operator's Manual

Pre-Operation

B
50°C 122°F
104°F
40°C
86°F
30°C
68°F
20°C
50°F
10°C
32°F
0°C
14°F
-10°C
-4°F
-20°C
-30°C -22°F
-40°F
-40°C
7