Stopping The Engine; Shutdown; Disassembly And Cleaning; Water Hammering - Mi-T-M Corporation 2 Honda WTP-S02-1MGH Mode D'emploi

STOPPING THE ENGINE

IMPORTANT: TO STOP ENGINE IN EMERGENCY, TURN ENGINE SWITCH (D)
DOWN TO "OFF" POSITION.
1. Move throttle lever (C) fully to the right.
2. Turn engine switch (D) to "OFF" position.
3. Move fuel valve (A) left to "OFF" position.

SHUTDOWN

IMPORTANT: SHUTDOWN PROCEDURES SHOULD BE FOLLOWED AT THE
END OF EACH CLEANING OPERATION.
1. Run engine at idle for 2-3 minutes. (Refer to pictures on previous page)
2. Turn engine off by:
a. Moving throttle lever (A) fully to the right.
b. Turn engine switch (B) to "OFF" position.
c. Move fuel valve (C) left to "OFF" position.
3. Allow engine to cool, then wipe pump down with a damp cloth.

DISASSEMBLY AND CLEANING

1. Turn bolt counter clockwise.
2. Pull pump casing toward you from Volute casing.

WATER HAMMERING

CAUTION: DO NOT ALLOW ANY VEHICLE
TO RUN OVER THE DELIVERY HOSE.
DO NOT CLOSE THE DELIVERY VALVE
ABRUPTLY BECAUSE WATER-HAMMER
MAY OCCUR. THIS MAY RESULT IN
HEAVY DAMAGE TO THE PUMP.

STORAGE

1. Drain water after use.
CAUTION: WATER TRAPPED INSIDE PUMP
WILL FREEZE AND MAY DAMAGE THE
PUMP.
FROM PUMP BY REMOVING THE DRAIN
PLUG AFTER EACH USE, AND BEFORE
STORAGE.
2. Long storage. Refer to engine manual for long term
storage.
CAUTION: DO NOT SMOKE AS FUEL IS HIGHLY
FLAMMABLE.
10
Operation
AFTER USE, DRAIN WATER
Semi-Trash Pump Operator's Manual