SFA SANICOMPACT Comfort Notice D'installation page 13

UK
1
DESCRIPTION
This device is not designed for
persons (including children) with
limited physical, sensory or mental abilities,
or those with minimal experience and know-
ledge, unless they are monitored and are gi-
ven the necessary instructions for using the
device, with the help of a person responsible
for their safety. Monitor children and make
sure they do not play with the device.
2
APPLICATIONS
Sanicompact ® is a specially designed WC with
an integral pump / macerator to discharge WC and
washbasin waste*. (*: depending on the model).
3
INSTALLATION
The fitting and working of your appliance must meet
local regulations and the EN 12056-4 standard.
To optimise the latest technical developments
concerning soundproofing incorporated into this
unit, it is important to:
with a partition or wall of the room
not more than one metre between the fastenings.
CONNECTION TO THE WATER SUPPLY
Connect the water supply hose to a shut off valve.
Caution: The quality of the rinsing of the bowl
depends on the water pressure.
sandy), we advise you to add a filter between the
shut off valve and the toilet to prevent clogging
of the solenoid valve.
CONNECTION TO THE ELECTRICAL SUPPLY
The electrical installation should
be carried out by a qualified person.
The unit requires a 220/240V single phase AC
50 Hz supply (UK specification).
The power supply circuit of the appliance must
be earthed (Class I) and protected by a GFCI
high sensitivity (30mA). Warning: Ensure the
electricity is turned OFF at the main switch
board before wiring to connector.
All wiring must conform to BS7671, 1992 require-
ments for electrical installations. Do not connect the
unit to a conventional plug and socket. It must be
wired into a fused, unswitched, fixed wiring
connector fitted with a 5 amp fuse. The wires
in the mains lead are coloured in accordance with
the following code:
Brown - Live
Blue - Neutral
power the device. All work on cable, pressure
chamber and motor should only be carried out
by a qualified Saniflo servicing agent, as special
tools are required. Please do not cut/shorten
the electrical supply cable which can make it
very difficult to remove in the event of a service
requirement.
4
COMMISSIONING THE UNIT
Connect to the power supply. Wait 20 seconds:
appliance initializing.
Open the water tap to rinse well. Start the nor-
mal flush by pressing the dark grey button. Put
a few sheets of toilet paper down in the bowl
and flush again.
PROGRAMMING
tronic programmer. Duration of operation varies
according to the cycle chosen.
- Eco flush (light grey button)
- Normal flush (dark grey button)
not enough.(Low supply pressure)
To re-programme:
for 5 seconds. (model without wash basin option)
(model with wash basin option)
have entered programming mode.
Each time you press the dark grey button you
increase the length of the flush by 1 second: each
time you press it will be validated by the motor
running for a short period.
decrease the length of the flush by 1 second:
each time you press it will be validated by the
6
FAULT FINDING / REMEDIES
IN ALL CASES, YOU MUST DISCONNECT
THE MACERATOR FROM THE POWER SUPPLY
-
SYMPTOMS
(24), the flush does not start
much water flows into the
toilet bowl
water flows into the toilet bowl
and the motor runs, but the
water in the toilet bowl is only
removed gradually or is not
removed at all
but a lot of water stays in the
toilet bowl
crunching sound, hums, but
does not run
activates
washbasin trap
does not run out automatically
7
GUARANTEE
2 year guarantee as from its date of purchase subject to correct installation and correct use.
Only the disposal of toilet paper, faecal matter, and waste water will be under
guarantee. Any damage due to foreign bodies such as cotton, condoms, sanitary towels,
wet wipes, food, hair, metal, wood or plastic objects, will not be under guarantee. Solvents, acids
and other chemicals can also cause damage to the unit, and will invalidate the guarantee.
5
motor running for a short period.
Note : Duration of operation varies according to
the cycle chosen.
Operating wash basin: Please make sure that the
-
wash basin tap draining into the sanicompact is
properly shut off after usage and not dripping.
5
MAINTENANCE
WARNING !!!
it is essential to turn off the water supply to protect
the installation against sub zero temperatures.
CARE OF YOUR UNIT
Descalent.
.Disconnect the macerator power supply,
.Pour an amount of cleanser into the pan
.Leave it to stand for 1 or 2 hours,
.Re-connect the macerator power supply,
.Rinse by operating the flushing system twice.
Carry out the operation once every 3 months on
average, but the frequency may need to be changed
depending on the hardness of the water.
PROBABLE CAUSES
is not active or the electrical power
supply is defective
valve (28) is clogged.
is leaking
control system
are dripping water
control
-
REMEDIES
check the electrical power supply
repair agent to intervene
service
(programming)
on the siphon (23)
valve
repair agent to intervene
valve