Bryton Rider 60 Guide De Démarrage Rapide page 9

• On the initial usage, do the following:
(1) Press the button. The LED blinks from red to green, indicating the sensor
is working.
(2) Start pedaling.
(3) When the cadence magnet comes across the sensor, the red LED blinks.
When the speed magnet comes across the sensor, the green LED blinks.
(4) The LED blinks only for the first 10 passes after pressing the button.
(5) If you want to check the alignment status after 10 passes, just press the
button.
Installing the Heart Rate Monitor (Optional)
1
4
Note:
• In cold weather, wear appropriate clothing to keep the heart rate belt warm.
• The belt should be worn under the chest and directly on your body.
• Adjust the sensor position to the middle part of the body (wear it slightly below
the chest). The Bryton logo shown on the sensor should be facing upward.
Tighten the elastic belt firmly so that it will not turn loose during the exercise.
• If the sensor cannot be detected or the reading is abnormal, please warm up for
about 5 minutes.
• If the heart rate belt is not used for a period of time, remove the sensor from the
heart rate belt.
Rider 60 Quick Start Guide
2 3
5
Sensors
Cadence
Heart Rate
Speed
Dual Sensor
60
PAGE
LAP
9