Klarstein Steeletto Mode D'emploi page 11

4
Insert the male
connector into the
female connector (from
the remote control
receiver to the fan, and
from the remote control
to the terminal block.
7
Lift up the canopy
into place over the
mounting plate. Ensure
that you do not trap
any wires.
5
Connect the wires
from the earthed mains
supply to the terminal
block.
8
Fasten the blade
assembly to the motor
with the screws and
spring washers already
attached to the motor.
6
Align canopy side holes
with the bracketss. Lift
fan until the screws
reach the bottom of
the slots and then
rotate the canopy
counterclockwise until
the screws drop into the
slot recesses.
9
Connect the light kit
by clipping together
the two plastic male/
female connectors.
EN
11