Electrical Connections - Erreka KUBAR Mode D'emploi

INSTALLATION
9

ELECTRICAL CONNECTIONS

Magnetic loop detector connection
40
Installation Guide
AEP1-009 / AEP1-09M
If necessary, a magnetic loop can be installed to detect
vehicles.
When a vehicle passes over the loop (LOOP) installed in
the ground, the detector (D.M) sends a key command
to the control panel. Vehicle exit can therefore be done
automatically.
O
Check the loop detector instructions for proper
installation and configuration.
P116X
SMF
Connector for light signal card -
flashing light (AEPS1-009)
ANT
Antenna connector
R.E.
Connector for plug-in receiver (except
RSD)
A.T.
Command device
S.G.
Safety device (photocell or mechanical
strip)
FC
Opening and closing limit switches
(supplied installed)
AUX
Power output for peripherals (24Vac,
300mA maximum)
M
Operator motor (supplied installed)
Controls
T.E.
Standby time regulation (only works in
automatic mode)
T.A.
Opening time regulation
T.C.
Closing time regulation
PUL1
Close mini-pushbutton
PUL2
Open mini-pushbutton
SW1
Main switch
SW2
Operation mode selector
(programming DIPs)
F1
Main fuse
(AEP1-009: 2.5A; AEP1-09M: 4A)