Installation; Tools And Materials; Initial Conditions And Checks; Unpacking - Erreka KUBAR Mode D'emploi

INSTALLATION

1

TOOLS AND MATERIALS

• Electrician's screwdriver
• Electrician's scissors
• Fixed wrenches
2

INITIAL CONDITIONS AND CHECKS

Environmental conditions

Ensure the ground is firm enough to support
the strain of the barrier.
 This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the power supply installation fulfils the
following requirements:
• The nominal voltage of the installation must
coincide with that of the control panel.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
3

UNPACKING

Fig. 2 Unpacking and content
• Allen keys
• Cement, sand

Check that the admissible environmental
temperature range for the device is suitable for
the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.

The electrical cable section is indicated in: "Fig. 1
Elements of the complete installation" on page 31.
O
KUBAR barriers have wooden wedges inside
for protection during transit, and these
should be removed. Dismount the covers (A)
and (B) and remove the wedges.

Check the content of the packages. Should it be
noticed that a piece is missing or deteriorated,
contact the nearest technical service.
R
Discard the packaging safely and in an
environmentally friendly manner.
Content:
1
Unit (structure + operator + mechanism +
control board)
2
Anchor plate with nuts
3
Arm support
4
Flange and screws
5
Arm (not included, supplied separately)
6
Keys
7
Manual operation crank
8
Installation Guide
English
33
KUBAR Barriers