Publicité
Les langues disponibles
Les langues disponibles
WELDING
13
27 12
11
Please note:
When exceeding the
max. welding pressure
of 1000 N, mechanical
damage can occur.
26 25
1
4
5
6
– Welding pressure
Engage and position the automatic welding machine
onto the material to be welded. Tighten the tension
lever (10) without engaging the combi-wedge. Gently
tighten the drive/pressure rollers (22/23) with the
adjustment screw (11) onto the material to weld ed
touching the material only lightly. Unlock the lever
for the mechanism (27) and release the tension lever
(10) at the same time.
Following illustration A, rotate the adjustment screw
(11). Tighten the locking screw (12) by hand. As required,
adjust the pressure of the pinch roller (19) by using
the adjustment screw for pinch roller (13).
lb
(pound)
220
1000
202
179
157
134
112
90
67
45
23
max. welding pressure 1000 N
– Welding speed
Depending on the welding suitability of the film or
geomembrane liner and the effects of the weather,
set the welding speed with the potentiometer for
drive (26) according to the scale.
– Temperature
Adjust the welding temperature with the potentiometer
for heater (5). The air volume is adjusted with the two-step
switch (6) (depending on the material and combi-wedge).
Switch on the hot air blower (4). Heating up time
approx. 5 min.
[ N ]
Welding pressure
900
800
700
600
500
400
300
200
100
1 2 3 4 5 6 1 2 3 4
Illustration A
4
Screen
21
Publicité
