Sharp CD-M10000V Mode D'emploi page 19

To interrupt playback:
Press the CD button on the remote control.
To resume playback from the same point, press the
To stop playback:
Press the button.
To remove the video CDs:
Whilst in the stop mode, press the OPEN/CLOSE button.
The disc tray will open. Remove the two discs. Then, press the DISC SKIP button to
rotate the disc tray and remove the remaining disc.
z If the DISC SKIP button does not allow to rotate the disc tray (you cannot remove
the disc), close and open again the tray.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
„ To skip to the beginning of a track (skip
search)
To move to the beginning of the next track:
Press the PRESET button for less than 0.5 seconds during playback.
z You can skip to any track by pressing the
PRESET
desired track number appears.
To restart the track being played:
Press the PRESET button for less than 0.5 seconds during playback.
z You can skip to any track by pressing the
the desired track number appears.
[Example] When the current track is 9
Beginning of track 9
Notes:
z You can skip to the beginning of a track on a single disc only.
z The or button on the remote control allows you to locate the beginning of a
track.
„ Scan play
button.
For fast forward:
Press and hold down the
For fast reverse:
Press and hold down the
button repeatedly until the
Notes:
z Normal playback will resume when the
button is released.
z You can locate the desired portion on a single disc only.
z During scan play, colours may fade, pictures may be distorted, or noise bars may
PRESET button repeatedly until be seen.
z Pictures are shown intermittently and no sound is heard during fast forward or fast
reverse on video CDs.
z This can be operated by pressing the
Beginning of track 10
PRESET button during playback.
PRESET button during playback.
Current scene
PRESET or PRESET
or button on the remote control.
01/10/30 CD-M10000V(X)E2.fm
CD-M10000V
ENGLISH
1
2
3
4
5
6
7
E-18