Troubleshooting Guide - Panasonic DVD-LS80 Mode D'emploi

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt about some of the check
points, or if the solutions indicated in the chart do not solve the problem, consult your dealer for
instructions. (Reference pages are shown in parentheses.)
The following do not indicate malfunction.
≥Sound from the AC adaptor during recharging.
≥The battery pack warming up when recharging or during use.
≥The surface and area around the unit becoming warm when used for long periods.
Power
No power.
Unit turns off
automatically.
Cannot charge or the
[CHG] indicator fails to
light.
Play time dramatically
reduced after recharging.
No operation
No response when any
buttons pressed.
[DVD-LS82]
No response
when remote control
buttons pressed.
You have forgotten your
ratings password.
No picture or sound.
26
26
≥ Check connections to the AC adaptor or battery pack. (6)
≥ [DVD-LS82]
You cannot turn on the unit with the remote control if
the unit is powered by the battery pack.
≥ The unit has protection circuitry that is activated if it becomes too
hot or too cold. The unit will not work if this occurs. Use the unit
o
between 5 C and 35
≥ The unit turns off after it has been stopped for about 15 minutes
(5 minutes when the unit is powered by the battery pack) to
conserve power. Turn the unit on again.
≥ The charging time increases when the temperature is too hot or too
cold, and charging may not be possible under some circumstances.
≥ Check connections to the AC adaptor or battery pack. (6)
≥ The battery pack has reached the end of its service life (It can be
recharged about 300 times).
≥ This unit cannot play discs other than the ones listed in these
operating instructions. (4)
≥ The unit may not be operating properly due to lightning, static
electricity or some other external factor. Turn the unit off and then
back to ON. Alternatively, turn the unit off, disconnect the power
source (AC or battery pack), and then reconnect it.
≥ Condensation has formed: Wait 1 to 2 hours for it to evaporate.
≥ Please insert the disc correctly. (8)
≥ Check that the battery is installed correctly. (7)
≥ The battery is depleted: Replace it with new one. (7)
≥ Point the remote control at the remote control sensor and operate.
(7)
≥ While stopped, press and hold [:] and [;] on the unit and then
also press and hold [1, ON] on the unit until "Initialised" disappears
from the screen. Turn the unit off and on again. All settings will
return to the default values.
≥ Check that the disc has something recorded on it.
o
C.