Table des Matières
Publicité
3. CARING FOR yOUR MACHINE
REPLACING THE CUTTER
Replace the Moving cutter if it becomes blunt. A spare cutter can be found in your accessories.
NOTE: You should not need to replace the fixed cutter which is made of a special hard alloy material.
Remove the power cord plug from the power supply outlet.
Remove the stitch finger.
1.
Open the working table. Using the wrench, losing the screen and take out the Moving
cutter.
2.
Lower the cutter diring arm to the middle position by turning the cutter release knob
toward you. In this position, set the replacement cutter in position and secure it with
the screw. ENSURE THAT THE EDGE OF THE MOVING CUTTER (1) IS
APPROXIMATELY 0.5 mm BELOW THE SURFACE OF THE FIXED CUTTER (2).
DISENGAGING MOVING CUTTER
If you want to sew without cutting, open the working table and disengage the Moving cutter
by pushing the cutter release knob to the left and turning it toward you until the cutter snaps
into the lowest position.
Ensure that fabric edge is not wider than overedge width selected or upper looper and needle
can be damaged.
CHANGING THE LIGHT BULB
Disconnect from power supply before removing face cover.
Remove the face cover screw and take off the face cover.
1.
Push up the bulb slightly and turn counterclockwise.
2.
Insert the new bulb (15 W), push up and turn clockwise.
Illustration
*I:
Screw
*II: Stitch finger
*III: Moving cutter
*IV: Cutter release knob
*V: Face cover
*VI: Face cover screw
*VII: Light bulb
56
*
I
*
V
*
VI
*
III
*
II
*
IV
15 W
1
2
*
VII
Publicité
Table des Matières
