Storing Your Own Sound Adjustments - JVC KD-LH1101 Manuel D'instructions

Storing your own sound
adjustments
You can adjust the sound modes to your
preference and store your own adjustments in
memory (User 1, User 2, and User 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press SEL (select) once.
The next-step-operation
buttons start flashing.
Ex.: When you select "Country" previously
2
Select the sound mode you want to
adjust.
• This unit has two sound mode selection
screens. To move to the other screen,
press 5 (up) or ∞ (down).
3
Enter the sound adjustment mode.
The following sound
mode adjustment
screen appears on the
display.
4
Make adjustments as you like.
Press ¢
1)
frequency band—60 Hz, 150 Hz,
400 Hz, 1 kHz, 2.4 kHz, 6 kHz, 12 kHz.
Press 5 (up) or ∞ (down) to adjust the
2)
level of the selected band within the
range of –05 to +05.
3)
Repeat steps 1) and 2) to adjust the
other frequency bands.
5
Store the adjustment you made.
The confirmation message
appears—whether you want to
store the adjustment.
If you want to cancel the adjustments,
press SEL (select).
• Adjustment you made remains effective
until you select another sound mode.
6
Select one of the user sound modes
(User 1, User 2, or User 3) you want
to store into.
Ex.: When you select "User 1"
or 4
to select the
29