Publicité
Les langues disponibles
Les langues disponibles
- English -
Installation
WARNING
Risk of electric shock. To reduce the risk of electric shock, be certain that it is connected only to a properly grounded,
grounding-type receptacle.
Attention! Do not exceed the voltage shown on the transformer.
!
Do not submerge the transformer and sensor.
To reduce the risk of fire or injury, keep lamp away from materials that may burn.
Note:
● The unit is supplied as a complete set with a transformer, a sensor and one, three, or six LED spotlights.
Important:
●
Do not lift the light or the transformer by its power cord.
●
Keep the cord away from high temperatures or other heat sources.
●
Use a proper power source as indicated on the transformer label.
1. Connect the light to the sensor by pushing the plug into the
sensor socket until it is firmly seated. Hand tighten the nut from
the plug to the socket.
2. Connect the sensor to the transformer by pushing the plug
into the transformer socket until it is firmly seated. Hand
tighten the nut from the plug to the socket.
3. Place the lights in or out of the water.
○ Make sure that the transformer and sensor are NOT
submerged.
○ Make sure that the light sensor faces up. Position the unit in
such a way that it does not present a hazard to anybody.
NOTE: At night, the lights will automatically turn on. At sunrise,
they will automatically turn off.
4. If needed, adjust the angle of the lights by moving the head.
1.
plug from
light
nut
2.
3.
side to side pivoting
light
sensor
360° pivoting
4
Publicité
