Publicité
Les langues disponibles
Les langues disponibles
GB
Thank you for having chosen our IBIZA LIGHT POWER STROBE. For your own safety, please read this user
manual carefully before installing the device.
SAFETY INTRODUCTION
If the device has been exposed to temperature changes due to environmental changes, do not switch it on
immediately. The arising condensation could damage the device. Leave the device switched off until it has reached
room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed. A qualified person must
carry out the electric connection.
Make sure that the available voltage is not higher than stated at the end of this manual.
Never operate the stroboscope without glass pane or with a broken glass pane. Ask your dealer or authorized agent
to replace the glass pane.
Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or authorized agent to
replace the power cord.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power cord
by plug. Never pull out the plug by tugging the power cord.
During initial start-up, some smoke or smell may arise. This is normal and should decrease gradually.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.
Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that
their effectiveness is impaired, for example by cracks or deep scratches.
The lamp shall be changed if it has become damaged or thermally deformed
CAUTION:
1. Be very careful during installation. Since you will be working whit a dangerous voltage you can suffer a
life-threatening electric shock when touching live wired.
2. Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
3. Please be aware that damages caused by manual modifications to the device are not subject to warranty. Keep
away from children and non-professionals.
GENERAL GUIDELINES
This device is a stroboscope for decorative effects. This device is only allowed to be operated with and alternating
current of max. 240VAC/50Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating it.
When choosing the installation spot, please make sure that the device is not exposed to extreme heat, moisture or
dust. The minimum distance between light-output from the projector and the illuminated surface must be more than
0.5 meter.
Operate the device only after having familiarized yourself with its functions. Do not permit operation by person not
qualified for operating the device. Most damages are the result of unprofessional operation.
Please use the original packaging if the device is to be transported.
For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other
operation may lead to short-circuit, burns, electric shock, lamp explosion, crash, etc. If this device will be operated in
any way different to the one described in this manual, the product may suffer damages and the guarantee becomes
void.
© Copyright LOTRONIC 2011
STROBE75
Page 2
Publicité
