Adjusting The Fan Speed; Fan Only - Technibel Climatisation SPA 250 X5 TA Série Mode D'emploi

Operation with the Remote Control Unit
(continued)
•
NOTE
•
2. Adjusting the
Fan Speed
A. Automatic Simply set the FAN SPEED selector to the
A microcomputer in the air conditioner automatically controls the fan
speed when the
operating, the difference between the room temperature and the set
temperature is detected by the microcomputer which then automatically
switches the fan speed to the most suitable level.
Cooling mode:
The above table assumes that the sensor on the remote control is being
NOTE
used. If the sensor on the indoor unit is being used (the
on), actual operation may differ slightly from the operation described in
the table.
(Refer to ''A/C SENSOR button'' on page 9.)
B. Manual If you want to adjust fan speed manually during operation, just set the
FAN SPEED selector as desired. [

3. Fan Only

If you want to circulate air without any temperature control, follow these
steps:
STEP 1: Press the MODE selector button to switch to the fan mode.
STEP 2: Press the ON/OFF operation button.
STEP 3: Press the FAN SPEED button to select the fan speed of your
Choose the best position in the room for the remote control unit,
which also acts as the sensor for room comfort and transmits the
operating instructions. Once you've found this best position, always
keep the remote control unit there.
This appliance has a built-in 3-minute time delay circuit to ensure
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the
unit will restart automatically after three minutes.
mode is selected. When the air conditioner starts
When difference between
room temperature and set
temperature is
2 °C and over
Between 2 °C and 1 °C
Below 1 °C
MODE
STEP 1
FLAP
FAN SPEED
STEP 3
SELECT
( )
choice ( , , or
position.
FAN SPEED
High
Medium
Low
, , or ]
ON I /OFF
NIGHT
OFF ON
SETBACK
CLOCK
HH TIMER
SELECT
MM
A/C
ACL
TIME SET
SENSOR
BATTERIES
).
indicator is
STEP 2
13