LaserLiner ThermoVisualizer Mode D'emploi page 21

14 Measurement-specific settings: Temperature range manual / automatic
!
The min/max values last measured are taken as the default setting every time the temperature
range is switched from AUTO to Manual.
15 Measurement-specific settings: Manual temperature range
16 Measurement-specific settings: Colour pallet
You can choose from several standard colour ranges to represent the measured infrared temperatures.
Depending on the colour palette, the measured temperatures are adjusted within the current image
section and displayed in the respective colour space. The bargraph for the respective minimum/
maximum temperatures of the entire image serves as a reference for the corresponding temperature/
colour mapping.
Ironbow
Automatic temperature range
This setting is used to adjust the temperature range of the IR image and the
resulting distribution of the colour spectrum of the infrared image. The colour
spectrum of the measured IR image is determined in relation to the temperature
range and colour scale.
The colour distribution of the IR image is automatically and dynamically adjusted
in the bargraph based on the measured min./max. values.
Manual temperature range
In manual settings mode, the temperature range is no longer set automatically
based on the measured min./max. values but rather determined on the basis of
manual values. Refer to Section 15.
Main Menu
Language
Manual range
2/2
Rainbow
ThermoVisualizer
Manual range
Settings
Max: 24°C
Min: 20°C
Back to Menu
High contrast
Manual range
Settings
Max: 24°C
Min: 20°C
Back to Menu
T=-20°C
Increase value
Decrease value
Grey scale
21
EN