LaserLiner ThermoVisualizer Mode D'emploi page 20

12
Measurement-specific settings: Temperature range, low
An alarm sounds to signal whether the temperature at the measuring point is below the set temperature
range.
Main Menu
E: 0.95
HAL Temp: 250°C
LAL Temp: -20°C
Auto off: 1 min
Backlight
Date / Time
Time Stamp
Erase file
Save File as
Noise Filter
1/2
13
Measurement-specific settings: Noise Filter
The image interference of the sensor is reduced by switching on the noise filter. With the filter switched
off, the unfiltered image interference of the sensor will be displayed.
Main Menu
E: 0.95
HAL Temp: 250°C
LAL Temp: -20°C
Auto off: 1 min
Backlight
Date / Time
Time Stamp
Erase file
Save File as
Noise Filter
1/2
20
EN
Low Alarm
Settings
LAL Temp: 30°C
LAL Temp: 20°C
LAL Temp: 10°C
LAL Temp: 0°C
LAL Temp: -20°C
Set LAL Temp
On / Off
Back to Menu
Noise Filter
Settings
Filter ON
Filter OFF
Back to Menu
Low Alarm
Settings
LAL Temp: 30°C
LAL Temp: 20°C
LAL Temp: 10°C
LAL Temp: 0°C
LAL Temp: -20°C
Set LAL Temp
On / Off
Back to Menu
T=-20°C
ON
OFF
Increase value
Decrease value