Berner BACOT 12V STARLOCK Notice Originale page 19

Selecting an application tool
Please observe the application tools intended for
your power tool.
Application tool
Application tool
Bi-metal seg-
ment saw blade
Sanding plate
for Delta series
93 mm sanding
sheets
Profile sander
Bi-metal plunge
cut saw blade
for wood and
metal
HCS plunge
cut saw blade
for wood
Bi-metal plunge
cut saw blade
for hardwood
TC plunge cut
saw blade,
metal
Bi-metal plunge
cut saw blade
for wood and
metal
1 609 92A 4RW • 17.12.18
Application tool
English
BACOT 12V
STARLOCK
Material Application
Wood-based materi- Separating cuts and plunge saw cuts;
als, plastic, non-fer- including sawing close to edges, in corners
rous metals and in difficult-to-reach areas;
example: Shortening skirting boards that are
already installed or door frames, plunge cuts
when adapting floor panels
Depends on the Sanding surfaces at edges, in corners or in dif-
sanding sheet ficult-to-reach areas;
depending on the sanding sheet, e.g. for sand-
ing wood, paint, varnish, stone;
fleeces for cleaning and for texturing wood, re-
moving rust from metal and for keying varnish,
polishing felt for pre-polishing
Wood, pipes/pro- Convenient and efficient sanding of profiles up
files, paint, varnish, to a diameter of 55 mm;
filler, metal red sanding sheets for sanding wood, pipes/
profiles, varnish, filler and metal
Softwood, soft Small separating cuts and plunge cuts;
plastics, plaster- example: Cutting a recess for sockets, cutting
board, thin-walled a copper pipe so that it is flush with a surface,
aluminium profiles making plunge cuts in plasterboard
and non-ferrous
Delicate adaptation work in wood;
metal profiles, thin
example: Sawing recesses for locks and fit-
sheet metal, non-
tings
hardened nails and
screws
Wood-based materi- Separating cuts and plunge saw cuts;
als, soft plastics including sawing close to edges, in corners
and in difficult-to-reach areas;
example: Thin plunge cut in solid wood for in-
stalling a ventilation grille
Hardwood, lamin- Plunge cuts in laminated boards or hardwood;
ated boards example: Installation of skylights
Metal, extremely ab- Plunge cuts in extremely abrasive materials or
rasive materials, metal;
fibreglass, plaster- example: Cutting kitchen front covers, easy
board, cement-bon- cutting through hardened screws, nails and
ded fibreboard stainless steel
Softwood, hard- Plunge cuts in laminated boards or hardwood;
wood, veneered example: Shortening door frames, recesses for
boards, plastic- a shelf
coated boards, non-
hardened nails and
screws
BACOT 12V
STARLOCK
English | 19