Publicité
Les langues disponibles
Les langues disponibles
OPENING THE DOOR
While a programme or the Delay Start operates, the
appliance door is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high and the drum still rotates, you
cannot open the door.
To open the door during the first minutes of the
cycle or when the Delay Start operates:
1. Press the button Start/Pause to pause the
appliance.
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button Start/
Pause again. The programme (or the Delay
Start) continues.
AT THE END OF THE PROGRAMME
•
The appliance stops automatically.
•
The acoustic signal operates (if it is activated).
•
In the display
comes on.
•
The indicator of the button Start/Pause goes off.
•
The door lock indicator
Turn the programme knob to position
deactivate the appliance.
•
You can open the door.
•
Remove the laundry from the appliance. Make
sure that the drum is empty.
•
Close the water tap.
•
Keep the door and the detergent drawer ajar, to
prevent the mildew and odours.
HINTS AND TIPS
THE LAUNDRY LOAD
•
Divide the laundry in: white, coloured,
synthetics, delicates and wool.
•
Obey the washing instructions that are on the
laundry care labels.
•
Do not wash white and coloured items together.
•
Some coloured items can discolour with the first
wash. We recommend that you wash them
separately for the first times.
•
Button up pillowcases, close zippers, hooks and
poppers. Tie up belts.
•
Empty the pockets and unfold the items.
•
Turn multilayered fabrics, wool and items with
painted illustrations inside out.
•
Remove hard stains.
•
Wash heavy soil stains with a special detergent.
is on.
goes off.
goes off.
to
The washing programme is completed, but
there is water in the drum:
•
The drum turns regularly to prevent the creases
in the laundry.
•
The indicator Rinse Hold stays on to remind you
to drain the water.
•
The door lock indicator
of button Start/Pause flashes. The door stays
locked.
•
You must drain the water to open the door.
Draining the water:
1. To drain the water.
•
Set a Drain or a Spin programme.
•
Press the button Start/Pause. The
appliance drains the water and spins.
2. When the programme is completed and the
door lock indicator
the door.
3. Turn the programme knob to the position
deactivate the appliance.
STAND BY
Some minutes after the end of the washing
programme, if you do not deactivate the appliance,
the energy saving status activates. The energy
saving status decreases the energy consumption
when the appliance is on the standby:
•
All indicators and the display go off.
•
The indicator of button Start flashes slowly.
Press one of the buttons to deactivate the energy
saving status.
•
Be careful with the curtains. Remove the hooks
and put the curtains in a washing bag or
pillowcase.
•
Do not wash laundry without hems or with cuts.
Use a washing bag to wash small and/or
delicate items (e.g. underwired bras, belts,
tights, etc. ).
•
A very small load can cause balance problems
with the spin phase. If this occurs, adjust
manually the items in the tub and start the spin
phase again.
STUBBORN STAINS
For some stains, water and detergent is not
sufficient.
We recommend that you pre-treat these stains
before you put the items in the appliance.
is on. The indicator
goes off, you can open
to
13
Publicité
