Teckentrup CarTeck 40.1 Notice De Montage Et D'utilisation page 38

38 Connection and function of Warning lamp and traffic light
Clearing-time = advance warning before closing
If clearing-time is programmed the door will close only after warning lamp has finished flashing.
The door will close after ream-time procedure. Possible parameters are 0 sec. until 300 sec.
Activate and deactivate clearing-time:
1
2
3
4
Activate clearing-time:
5
Deactivate clearing-time:
6
Subject to technical modifications without prior notice.
Press TL 5 sec. until LED yellow lights permanently.
Press TL 5 sec. again until LED red lights permanently.
Press TL 5 sec. again until LED yellow begins to flash.
Press TL 5 sec. until LED red begins to flash.
Press TS briefly until LED red and yellow begins to flash in sequence.
Now start counting and choose time (from 1~300 sec).
Press TL 1sec. again until LED red and yellow turn off.
Press TS briefly until LED red and yellow begins to flash in sequence.
Press TL and maintain pressed until LED red and yellow turn off.
About 5 sec. Ream-time is now deactivated.
TP-40. 1 -07/13