Teckentrup CarTeck 40.1 Notice De Montage Et D'utilisation page 34

34 programming partial opening
Please drive the door to the desired position by pressing the
1
TS button twice.
2
3
4
5
6
Attention: Programming partial opening causes the light-on-off
function in the 2nd channel to be switched off.
Attention: Any mistakes pressing the buttons can only be deleted by
switching off and pulling out the 230 V plug. Then repeat
the procedure as outlined again.
Subject to technical modifications without prior notice.
Press TL 5 sec. until yellow LED lights permanently.
Press again TL 5 sec. until red LED lights permanently.
Press TS 1 sec. until red LED lights permanently.
Confirm partial opening:
Press TL, red LED turns off.
Erase partial opening:
Press TS, red LED turns off.
TP-40. 1 -07/13