Teckentrup CarTeck 40.1 Notice De Montage Et D'utilisation page 37

Hold-open-time = Time until clearing-time start
If automatic closure is on (DIP1= ON), then hold-open-time will count in time to when the door has
arrived at it's closed position. If hold-open-time is already counted then the door will close automatically.
Possible parameters are 0 sec. until 300 sec.
If the door is open and there is a signal given to the hand transmitter or radio transmitter the
automatic closure will start counting again. The automatic closure is free when counting time has
been finalised. The door will close if time has been finally counted and if no signal such as hand transmitter
or radio transmitter was given.
Activate hold-open-time with direct closing
1
2
3
4
5
Attention:
To avoid any failure, please switch off the power supply and pull out the plug then data can be erased.
Subject to technical modifications without prior notice.
Connection and function of Warning lamp and traffic light 37
Press TL 5 sec. until LED yellow lights permanently.
Press TL 5 sec. again until LED red lights permanently.
Press TL 5 sec. again until LED yellow begins to flash.
Press TL 5 sec. until LED red begins to flash.
Press TS briefly until LED red and yellow begins to flash in sec.
Now start counting and choose time (from 1~300 sec).
Press TS 5sec. again until LED red and yellow turn off.
TP-40. 1 -07/13