Publicité
Les langues disponibles
Les langues disponibles
PANEL DESCRIPTION
1
ATTENUATOR
Before making any connections set this switch to match the PDI 03
JB to your input source. Select the 24 dB setting for amplifiers
with a maximum output of 200 watts, switch to 12 dB for low-wattage
amps with a maximum ouput of 10 watts, or use the 0 dB setting for
line level preamps and instrument level pedals.
2
INPUT
Connect the speaker output of your amplifier to this jack using a
quality ¼" plug loudspeaker cable. To connect preamps and pedals
use a quality ¼" plug instrument cable.
3
THRU
Connect this jack to your guitar speaker or cabinet using a quality
¼" plug loudspeaker cable.
WARNING: FOR DIRECT RECORDING FOR YOUR AMP WITHOUT A LOUDSPEAKER OR
CABINET, CONNECT A DUMMY LOAD WITH EQUIVALENT OHMS RATING TO THIS
JACK (E.G. THE PALMER PDI 06).
NEVER USE THE PALMER PDI 03 JB WITHOUT A SPEAKER OR SUITABLE LOAD
CONNECTED TO THIS JACK TO PREVENT SEVERE DAMAGE TO YOUR AMP!
NOTE: NO LOAD IS REQUIRED WHEN USING THE PDI 03 JB WITH PREAMPS AND
PEDALS.
4
BALANCED
This XLR output provides a transformer balanced feed of the
frequency compensated signal for DI. Connect the XLR socket to the
microphone input of a mixing console, recording gear or soundcard
using a quality microphone cable.
9 9 9
Publicité
