Publicité
Les langues disponibles
Les langues disponibles
Daihatsu Sirion/YRV
2001 - .....
Ref. 1292
Fitting instructions
1)
Remove the inner coating in the trunk and remove the spare wheel.
2)
Enlarge, on both sides of the vehicule, the 2 openings in the rear of the chassis till ø17mm (see photo).
Insert the heightened washers at the bottom of the chassis. Place afterwards the tow bar with point C over
the towing ring and insert the bolt.
The points B are matching with the inserted heightened washers. Perforate those points perpendicular
with ø10,5mm till in the trunk.
Place the washers 50x40x12x2 in the trunk, insert the bolts but do not tighten yet.
3)
The points B are matching with the provided drillings in the underside of the cross-beam (see photo 1).
Drill also these points through till in the trunk. Enlarge, in the trunk, these holes till ø17mm.
Insert the heightened washers and bolts but do not tighten yet.
4)
Place the ball and tighten everything firmly.
Composition
1 tow bar reference1292
1 ball T45L000
2 bolts M12x65
2 bolts M12x60
4 security nuts M12
1 security shackle
2 mounting pieces T45
2 tubes T45
1 bolt M12x70
1 security washer M12
1 nut M12
4 bolts M10x60
2 bolts M10x80
6 security washers M10
6 nuts M10
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
4 washers 50x50x12x2
(*)
4 washers 40x35x12x4
(*)
2 heightened washers 50x50x12.5x50mm
(*)
2 heightened washers 50x50x12.5x35
(*)
2 heightened washers 50x35x12.5x35
(*)
(*)
(C)
(C)
(C)
(A-A')
(B)
(A-A'-B)
(A-A'-B)
All bolts and nuts : quality 8.8
(A-A')
(B)
(A)
(A')
Publicité
