Publicité
Les langues disponibles
Les langues disponibles
To do this, open the flap up to the safety stop
(the flap opens to a slight angle, Fig. 28) and
pull outwards. In order to refit it, line the
lower studs on the flap up with the holes on
the casing until the studs meet the clips on
the casing.
Storage requirements
When the appliance is out of use for a long
period, set the expulsion tube to parking
position so that the appliance takes up as little
space as possible.
To do this, bend the tube towards the back
of the appliance and secure it with the
diffusion hook. Figs. 32 and 33.
Prior to use at change of season
Clean the air filter.
Clean the casing and the grilles if
necessary.
Things to check before calling the Technical Service
General requirements for operation
What to do if...
... the appliance does not work ...
Check that it is plugged in properly.
Make sure that the control knob is not set to
off
.
Check that the mains electricity supply is
working. Check the fuse box.
Set the thermostat to a lower temperature.
... the appliance does not work and the light
indicating that the condensed water tank is
full is on ...
Set the appliance on a flat surface. If the
light does not go out, empty the internal
water tank. (See instructions in "cooling").
... the appliance does not reduce room
temperature sufficiently ...
Check the joins on the hot air expulsion tube.
Cleaning and Maintenance
31
Make sure that the expulsion tube is not too
bent and that it is not extended to more
than 140 cm.
Make sure that the plug is fitted on the
drainage water pipe.
Fit the suction pad to close the window as
far as possible.
Lower blinds to reduce direct sunlight.
... there is water on the control panel grille
or on the basic filter housing ...
There is no cause for concern. This is
normal.
Noise
... the appliance makes a lot of noise ...
Some noise is normal and other types of noise
can be solved easily. You need to be able to
distinguish between these types of noise:
Fig. 32
Fig. 33
Publicité
Chapitres
