Publicité
Les langues disponibles
Les langues disponibles
Cleaning the appliance
For safety reasons, you should unplug the
appliance from the mains electricity supply
before cleaning.
The appliance can be cleaned with a cloth
or sponge, slightly warm water and a mild
detergent.
Never use hot water (more than 40ºC),
bleach, benzene, petrol, acid, scouring
pads, brushes or strong detergents. Prevent
water from entering the appliance.
Do not clean the appliance with a hose.
Cleaning and changing the purifying
filters
Press the side tabs, (Fig. 28, 1.), on the front
flap of the appliance and pull it open (it is not
necessary to remove it), (Fig. 28, 2.). The flap
is fitted with a stop and can be opened up to
this point without risk of falling.
Fig. 28
All models are fitted with a basic filter which
needs to be cleaned regularly, Fig. 29. The
filter is accessed by pressing the tab at the top
and removing it from its housing, Fig. 30. The
filter is cleaned under a cold tap, dried and
replaced.
Washable
basic filter
Cleaning and Maintenance
Fig. 29
30
Apurifying filter is also fitted inside the basic filter
on some models.
Purifyng
filter
This purifying filter needs to be changed every
year in order to remain operational.
(These accessories are available for purchase
from the Manufacturer's Official Technical
Service and authorised distributors). See
"Description of accessories".
Installing the purifying filter:
Remove the basic filter from the appliance,
Fig. 30.
Fit the purifying filter inside the basic filter
as shown in Fig. 31.
Install the assembly onto the appliance by
lining the lower studs up with the slots on
the front casing of the appliance and
pressing the top clip in until it clicks into
position. The assembly is fitted properly
when it clicks into position.
Close the front flap.
In order to maintain cooling power, only fit
one set of filters onto the support.
Note
The front flap can also be removed in order
to clean the appliance or change the filters
more easily.
Fig. 30
Fig. 31
Publicité
Chapitres
