Cleaning, Transportation And Maintenance - Bosch PAS0720 Mode D'emploi

Cleaning the appliance
For safety reasons, you should unplug the
appliance from the mains electricity supply
before cleaning.
The appliance can be cleaned with a cloth
or sponge, slightly warm water and a mild
detergent.
Never use hot water (more than 40ºC),
bleach, petrol, acid, scouring pads, brushes
or strong detergents. Prevent water from
entering the appliance.
Do not clean the appliance with a water
hose or compressed air.
Cleaning and changing the purifying
filters
Press the side tabs, (Fig. 26, 1.), on the front
flap of the appliance and pull it open (it is not
necessary to remove it), (Fig. 26, 2.). The flap
is fitted with a stop and can be opened up to
this point without risk of falling.
Fig. 26
All models are fitted with a basic filter which
needs to be cleaned regularly, Fig. 27. The
filter is accessed by pressing the tab at the top
and removing it from its housing, Fig. 28. The
filter is cleaned under a cold tap, dried and
replaced.
Washable
basic filter
Cleaning and Maintenance
Fig. 27
44
Warning!!!
Do not try to clean the basic filter in a
dishwasher. The plastic on the basic filter
is not suitable for dishwashers and is
unable to withstand the high temperatures
involved in washing programmes. It will
deform and may even break.
These models also come with a purifying filter
(double active) to be fitted by the user (See
"Fitting the purifying filter").
The purifying filter further purifies the air in
the room which passes through the
appliance.
When the purifying filter is fitted, the
appliance's cooling capacity may drop
slightly. This is particularly the case when
the filter is saturated or worn. It is,
therefore, recommended that you check
and change the filter at least once a year or
when the "change filter" symbol
displayed. These accessories are available
for purchase from the Manufacturer's Official
Technical Service and authorised distributors
(See "Description of accessories").
Press the "+" and the "–" key at the same time
to make the symbol
screen after changing the filter. The symbol
disappears from the screen and the filter is
operational again.
Fitting the purifying filter (double active):
• Check that the purifying filter is fitted in the
positioner. If it is not, fit as shown on Fig
29. Place the dark part of the filter in contact
with the positioner.
Fig. 28
is
disappear from the