Brevi TAZIO tt 534 Mode D'emploi page 15

4. Pull the vehicle belt 22 out and guide it through the belt guides
of the child seat. Make sure that the belt is not twisted (fig. F20)
5. Engage the buckle tongue in the vehicle seat buckle 29 this
should make a click noise (fig. F21)
6. On the side opposite the car seat belt buckle, swivel clamping
lever 24 and insert diagonal belt in belt lock-off 25 (fig. F22)
7. Apply your body weight to the child seat (kneel into the seat). At
the same time pull the diagonal belt strongly to tighten
8. Follow the steps in section securing your child with 5-point
harness
For the safety of your child, before every journey in the car check that:
• the child seat is firmly installed in the vehicle
• the belt is not twisted
• the diagonal belt is only clamped by the lock-off 24 which is
located on the opposite side from the car seat belt buckle 29 (fig.
F21, F22)
• the straps of the child safety seat are close to the body without
constricting the child
• the shoulder belts 08 are correctly adjusted and the straps are
not twisted
• the shoulder pads 19 are at the same level as your child's shoul-
ders (fig. F3)
• the buckle latches 20 are engaged in the harness buckle 21
(fig. F16)
4.3 Group 2 (15-25 kg) vehicle belt+ top tether
+5-point harness
1.Follow the steps in section 4.2 (to fix child seat by three point
belt.)
2.Take the top tether and if required, lengthen the belt by pressing
the top tether brake button to release the strap, pulling to adjust
as necessary (fig. F11).
3.Hook the snap hook 17 into the Top Tether anchoring point re-
commended in your vehicle owner guide. Look for this symbol in
your vehicle (fig. F12).
4.To tension the top tether, remove any slack by pulling on the
free end of strap until it is suitably tightened. The top tether will
be properly tightened when the tension indicator turns completely
green (fig. F13).
5.Follow the steps in section securing your child with 5-point harness
For the safety of your child, before every journey in the car check
that:
• the child seat is firmly installed in the vehicle
• the belt is not twisted
• the Top Tether (fig. F13) is tightly tensioned over the backrest of
the car seat and the tension indicator is green
• the diagonal belt is only clamped by the lock-off 24 which is
located on the opposite side from the car seat belt buckle 29 (fig.
F21, F22)
• the straps of the child safety seat are close to the body without
constricting the child
• the shoulder belts 08 are correctly adjusted and the straps are
not twisted
• the shoulder pads 19 are at the same level as your child's shoul-
ders (fig. F3)
• the buckle latches 20 are engaged in the harness buckle 21
534-01-161124-00 ISTRUZIONI SEGGIOLINO AUTO TAZIO TT.indd 15
(fig. F16)
4.4 Group 2 (15-25 kg) & group 3 (22-36 kg) vehicle
belt
1. Make sure that the child seats 5-point harness is removed cor-
rectly (see section 6)
2. Follow the steps in section 3.3 (to adjust headrest.)
3. Follow the steps in section 4.1 , install child seat with ISOFIX
and top tether (option).
TIP
For group 2 and 3 the ISOFix connectors and top tether have
been designed to improve stability. In case of problem during use
in your vehicle , it is possible to use without this option.
4. Have your child sit down in the child seat.
5. Pull out the vehicle seat belt and guide it in front of your child
to the vehicle seat buckle 29 . Engage the buckle tongue in the
vehicle seat buckle 29 CLICK! (fig. F26, F27)
CAUTION! Do not twist the belt.
6. Place the diagonal seat belt section 11 and lap belt section 28
on the side of the vehicle seat belt buckle 29 under the armrest
and into the red belt guide 23 of the child seat (fig. F27, F28).
7. Place the lap belt section 28 on the other side of the child seat
in the red belt guide 23 (fig. F28).
8. Guide the diagonal seat belt section 11 into the red belt holder
30 of the headrest 07 until it lies completely in the belt holder 30
and is not twisted (fig. F29).
9. Make sure that the diagonal seat belt section 11 runs over your
child shoulder bone, and not in front of his or her neck.
TIP
You can still adjust the height of the headrest 07 again here in
the vehicle.
For the safety of your child, before every journey in the car check
that:
• the lap belt section 28 runs through the light red belt guides 23
on both sides of the seat cushion
• the diagonal seat belt section 11 on the side of the vehicle seat
belt buckle 29 also runs through the light red belt guide 23 of the
seat cushion
• the diagonal seat belt section 11 runs through the dark red belt
holder 30 of the headrest
5. REMOVAL OF THE CHILD SEAT
1.To release the ISOFIX fastening, squeeze the safety buttons,
first on one side, then on the other (fig. F8).
2.Open the buckle of the vehicle seat belt and pull out the diago-
nal from lock-off.
3.To release the Top Tether anchoring, loosen the belt by pressing
the brake button of the adjuster. Then take the spring hook out of
the anchoring point.
4.Slide the ISOFIX locking arms back into the seat shell .
6.REMOVING THE 5-POINT HARNESS
1. Loosen the 5-point harness of the child seat as much as pos-
sible (fig. F30).
Back side of the child seat:
15
30/11/2016 15.29.41