Table Des Matières; What To Do Before Operation - Panasonic CU-5MX1SPP Manuel D'utilisation

CU-5MX1SPP
CU-8MX1SPP
CU-10MX1SPP
C
ONTENTS
What to do before operation .............................................................. 1
Remote controller and changeover switch: name and
function of each switch and display ................................................... 1
Warning ............................................................................................. 2
Operation range................................................................................. 2
Operation procedure.......................................................................... 2
Optimum operation ............................................................................ 5
Following symptoms are not air conditioner troubles......................... 5
Troubleshooting ................................................................................. 6
Thank you for purchasing this Panasonic air conditioner.
Carefully read this operation manual before using the air
conditioner. It will tell you how to use the unit properly and
help you if any trouble occurs. After reading the manual,
file it away for future reference.
W
HAT TO DO BEFORE OPERATION
This operation manual is for the following systems with standard
control. Before initiating operation, contact your Panasonic dealer for
the operation that corresponds to your system type and mark.
If your installation has a customized control system, ask your
Panasonic dealer for the operation that corresponds to your system.
Outdoor units (See figure 1)
Inverter series
heat pumps
Names and functions of parts (See figure 1)
1 Outdoor unit
2 Indoor unit
3 Remote controller
4 Inlet air
5 Outlet air
6 Cool/heat changeover remote control switch
(figure 1 shows systems with changeover remote control switches.)
CU-5~10MX1SPP
Urban Multi air conditioner
4PW12337-1
Page
cool/heat
changeover remote
control switch operation modes
J yes J no
Urban Multi air conditioner
R
EMOTE CONTROLLER AND CHANGEOVER
:
SWITCH NAME AND FUNCTION OF EACH
SWITCH AND DISPLAY
(See figure 2 and figure 3)
ON/OFF BUTTON
1
Press the button and the system will start. Press the button
again and the system will stop.
2 OPERATION LAMP (RED)
The lamp lights up during operation.
3 DISPLAY "
When this display shows, the system is UNDER CENTRALIZED
CONTROL. (This is not a standard specification.)
4 DISPLAY "
It is impossible to changeover heat/cool with the remote
controller when this icon is displayed.
5 DISPLAY " " "
CLEANING)
This display shows that the total heat exchange and the air
cleaning unit are in operation. These are optional accessories.
6 DISPLAY " " "
This display shows the current OPERATION MODE.
7 DISPLAY " " (INSPECTION/TEST OPERATION)
When the INSPECTION/TEST OPERATION button is pressed,
the display shows the mode in which the system actually is.
8 DISPLAY "
This display shows PROGRAMMED TIME of the system start or
stop.
9 DISPLAY "
This display shows the set temperature.
10 DISPLAY " " (FAN SPEED)
This display shows the set fan speed.
11 DISPLAY " " (AIR FLOW FLAP)
Refer to page 4.
12 DISPLAY " " (TIME TO CLEAN AIR FILTER)
Refer to the indoor unit manual.
13 DISPLAY "
Refer to page 3.
14 TIMER MODE START/STOP BUTTON
Refer to page 4.
Operation manual
" (UNDER CENTRALIZED CONTROL)
" (CHANGEOVER UNDER CONTROL)
" " " " " " " (VENTILATION/AIR
" " " " " " " (OPERATION MODE)
" (PROGRAMMED TIME)
" (SET TEMPERATURE)
" (DEFROST)
Operation manual
1