The Handle Installing; Shelves; To Remove A Shelf - CASO DESIGN WineChef Pro 180 Mode D'emploi

12.5.1

The handle installing

The wine cooler comes with one metal stainless
steel handle. To install simply screw them to the
door with the supplied screws.
To do this, slide the rubber seal on the back of
the door to the side to lay open the predrilled
holes. Use the included screws to install the
handle on the door.
12.5.2

Shelves

Storrage depending on kind of bottle and size.
You can store 8 bottles on each shelf.
You can remove each shelf to store larger bottles.
12.5.3

To remove a shelf

Remove all bottles from the shelves.
Removal of the fixed shelves:
Carefully pull out the shelf until this is no longer
possible.
Look at the shelf rail from the side.
You see a lever. There are 2 positions
1 = below - release with pressure at point A upwards
2 = up - release with pressure at point A down
Reach into the rail with one finger and change the position of the lever by pressing the lever.
Hold this new position of the lever appropriately on both sides of the shelf and then pull out
the shelf.
31