Unpacking; Disposal Of The Packaging; Setup; Setup Location Requirements - CASO DESIGN Sound & Cool Mode D'emploi Original

12.3 Unpacking

To unpack the device, proceed as follows:
 Remove the device out of the carton and remove the
packaging material.
 The appliance may be title by a max angle of 45 °, otherwise the cooling system can be
damaged.
 Clean the interior surface with lukewarm water using a soft cloth.
 After at least 12 hours, plugging the appliance into the wall outlet, than place food or
beverages in the appliance.
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.

12.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and
recycling-related points of view and can therefore be recycled. Returning the
packaging back to the material loop saves raw materials and reduces the quantities of
accumulated waste. Take any packaging materials that are no longer required to "Green
Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.

12.5 Setup

12.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
 Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
 Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
 Ambient temperature below 16°C or above 38°C will hinder the performance of the
appliance.
 This unit is not designed for use in a garage or any other outside installation.
 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
Please note
Please note
38