Feet; The Handle Installing; Shelves - CASO DESIGN WineChef Pro 126-2D Mode D'emploi Original

 The device can be built around with other cabinets. If you install cabinets around the
device, leave 12 mm of extra space on the side of the door hinge so you can still open
the door.
 WARNING! Do not close the ventilation openings in the device housing.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
12.5.2

Feet

There are different feet (3 bigger feet and 1 small foot).
To level your appliance, adjust the small foot at the bottom of the appliance.
12.5.3

The handle installing

The wine cooler comes with one metal stainless
steel handle. To install simply screw them to the
door with the supplied screws.
To do this, slide the rubber seal on the back of the
door to the side to lay open the predrilled holes.
Use the included screws to install the handle on the
door.
Then reinsert the rubber seal in the correct
position.
12.5.4

Shelves

Storrage depending on kind of bottle and size.
You can remove each shelf to store larger bottles.
To remove a shelf: Remove all bottles from the shelves.
Lift the shelf upwards and the gently pull it out, (eventually
untighten the screws).
► Ensure that the shelves are firmly engaged in place
before storing any bottles.
► Spread your bottles out as evenly as possible over the
shelves, so weight is not concentrated in one point;
and make sure your bottles will not touch the back of
the cabinet.
Please note
32