Filling Paste, Inserting, Pasting And Cutting Wallpaper; Cleaning And Maintenance - Storch Tapetomat E Mode D'emploi

Filling paste, inserting, pasting and cutting
wallpaper
Fill the agitated paste into the tub evenly, across the
entire width of the pasting unit. Unfold the lid and remo-
ve it in the open position.
Set the desired paste thickness on the left and right of
the stripping rail.
Then guide the wallpaper onto the pasting roller via the
insertion rollers and place it on the wallpaper lifting tools
over the pasting tub.
Position the lid, close it and evenly pull the wallpaper
over the hood (pasted surface pointing upwards) through
the pasting unit until you have reached the desired
length.
Then cut the wallpaper in the cutting guide of the lid
using the roller knife, fold the wallpaper strip and reset
the metre counter to 0.
If you are working with the machine table, fold the
pasted wallpaper along the table. In this process, initially

Cleaning and maintenance

With the Tapetomat E you have purchased a high-quality
pasting unit that is maintenance-free to a large extent.
However, please keep in mind that a certain amount of
maintenance considerably facilitates using the unit.
For this reason, thoroughly clean the unit after each use.
Place a bucket under the drain and remove the plug to
drain the paste. Push the remaining paste in the unit to
the drain using the cleaning tool.
Then open the lid, remove it from the pasting tub at an
place the pasted surfaces on one another, then once again
fold the wallpaper so that the dry sides are in contact with
each other.
Subsequently fold paste on paste until you have reached
the required wallpaper length.
Simply cut the wallpaper strip to the correct width using
the cutting rail on the table and the centimetre scale as
well as the cutter knife.
The stop and the holder on the wallpaper table prevent
the wallpaper from moving while you are cutting.
Cut strips can be placed on the stowage area below the
pasting table to soak.
angle of approximately 10° from a vertical position and
pull the pasting roller out of the bearing shells towards
the top.
Now clean the tub, pasting roller and lid with warm water
and remove any paste residue.
Allow the parts to dry and reassemble in reverse order.
29