Bosch ASM 32 Notice Originale page 19

OBJ_BUCH-1393-001.book Page 19 Friday, April 15, 2011 10:36 AM
The connection lead must be inspected for signs
of damage at regular intervals and may only be
used if in perfect condition.
If the supply cord is damaged, it must be re-
placed by a Bosch Service Centre.
Products sold in GB only: Your product is fitted
with a BS 1363/A approved electric plug with in-
ternal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Assembly
Ensure the cables are not trapped when
folding/unfolding top/bottom handles. Do
not drop the handles.
Handle assembly (see figure A)
Fix the handle bottom 6 to the body of the mow-
er using pivot pins 13.
Ensure that the pivot covers 12 are fitted to the
handle bottom 6.
Ensure that the handle stop 11 is fitted to
the right hand side when operating the
mower (ASM 32).
Attach the handle top 1 with the bolts and the
wing nuts to the handle bottom 6.
Note: Ensure that the cable clip supplied is used
to fix the cable to the handle.
Attach cable to cable restraint 5 ensuring that
sufficient cable slack is available. (see figure B)
Remove transport packaging/label from the
mower, the blades will require adjustment – see
"Blade Maintenance (see figure G)".
Snap together the grassbox and fitting/remov-
ing the grassbox (ASM 32) (see figure C1)
Snap together both top and bottom half
of the grassbox.
Attach/remove the grassbox as shown.
Bosch Power Tools
Snap together the grassbox and fitting/remov-
ing the grassbox (ASM 32 F) (see figure C2)
Snap together the grassbox.
Attach/remove the grassbox as shown.
Adjusting the Cutting Height (see figure D)
Stop, release switch lever and wait until the
motor stops before adjusting height. The
blades continue to rotate after the machine
is switched off, a rotating blade can cause in-
jury.
The lawnmower can be set to several cutting
heights.
For this purpose, press the height of cut lever 9
outward ( ) then move up or down ( ) to the
desired cutting height while supporting the
weight of the mover with the other hand.
For the first cutting of the season, a high cutting
height should be selected.
Operation
Starting
The blade continues to rotate for a few sec-
onds after the machine is switched off. Al-
low the motor/blade to stop rotating before
switching "on" again.
Do not rapidly switch off and on.
Note: To aid starting push handle down to lift
front wheels.
Starting (see figure E)
Press and hold the safety button 3.
Squeeze the switch lever 2 towards
0
the handle.
Release the safety button 3.
2
1
I
Stopping
Release the switch lever 2.
F 016 L70 798 | (15.4.11)
English | 19