Atlantic Colorfalls CC06 Mode D'emploi page 4

Remote Control Functions
On/Off Button
A
Touch for one second to turn on or off.
Mode Selection
B Touch for one second to switch between Color
Wheel and Preset Light Changing Modes
C Color Wheel
D Preset Light Changing Mode Selection (Forward)
E Preset Light Changing Mode Selection (Backward)
F Brightness / Speed (Up)
G Brightness / Speed (Down)
Preset Light Changing Modes
1 Solid Crystal White
2 Continuous full spectrum fade change
3 Solid Red
4 Solid Green
5 Solid Blue
6 Solid Aqua
7 Solid Purple
8 Solid Yellow
9 Red-Green-Blue jump change
Changing the Brightness and Speed
In Modes 1-8 and 14-16, you can use the F and G keys to change the brightness
of the light. In Modes 9-13 and 17, you can use the F and G keys to change the
speed of the light transitions. There are 8 levels for each.
Maintenance
Atlantic's Color Changing Colorfalls has a removable back plate for easy cleaning
of the interior of the spillway. To clean the interior of the spillway, simply remove
the screws on the back plate and remove the baffle (Figure 4). Remove any large
obstructions that may be present and wipe down the interior with a non-abrasive
cloth. Once finished, install the baffle and re-attach the back plate, making sure
that the gasket is in place to ensure a water-tight seal.
6
A B
C
D
E
F
G
Indicator Lamp
10 7 color jump change
11 Red-Green-Blue dimmer change
12 7 color dimmer change
7 color dimmer then
13
7 color jump change
14 Flashing Red
15 Flashing Green
16 Flashing Blue
17 Flashing Red and Blue
Back Plate
LED Light Strip
Figure 4
Caution: Be extremely cautious when tightening the screws. It is strongly recom-
mended that you tighten the screws with a hand held screwdriver. Over tightening
the screws could crack the back plate or strip the screw holes. The screws need
only be snug for the gasket to make a seal.
For winterizing, loosen the screws on the back plate to allow excess water to drain.
Once the water is removed from the interior of the spillway, retighten the screws.
Warranty
Colorfalls and all its components carry a one-year limited warranty. This limited
warranty is extended solely to the original purchaser commencing from the date of
the original purchase receipt and is void if any of the following apply:
• The cord has been cut or altered between the Colorfalls and the
Control Module.
• The Colorfalls has been misused or abused.
• The Colorfalls has been disassembled or modified other than as
described in this manual.
• The Control Module and/or Remote Control have not been adequately
protected from moisture.
Screws
Gasket
Baffle
Colorfalls Body
Inlet Plugs
7