Switch Between Mode 2 And Mode 1 - Carson HM-38 Mode D'emploi

g. Switch Between Mode 2 and Mode 1
1.
Unscrew the screws in the transmitter
cover, shown as the picture.
4.
B1
A1
• Pull out the screw in A1 and mount it in A.
• Pull out the spring in B1 and then mount it in B.
• Switch from C1 to C.
2.
Slightly separate the rear cover from the
front one of the transmitter.
B
A
C1 C
CARSON Helikopter MARINES HM-38 50 050 7025
Tool
3.
Pull out the pin D, as shown the picture.
5.
Pull in the pin D. Mount the rear cover and tighten
the screws, and move the throttle trim to the lowest
position. the switch process is finished.
GB
D
15