Device Description - Storch AutoMixx 50 l Mode D'emploi

Special safety instructions
1. Never start the mixer in open position.
2. Never start without a mixer bucket.
3. Do not open the mixer until the agitator has come to a complete standstill.
4. Never reach through the safety mesh with your hands, or push objects through it, when the mixer is switched on.
5. Never operate the mixer without the safety mesh.
6. The device has a safety switch that switches the motor off when the mixer unit is raised. To switch on, the mixer unit
must be completely lowered into the bucket and then switched back on. Before each use check that the safety switch
is working properly.
7. Always lock the swivel arm with the safety screw after closing the agitator.
8. Do not process materials with a flash point of below 22°C.

Device description

Support for swivel arm
in open state
Motor
ON/OFF
switch
Swivel arm
Safety switch
Height adjustment bolt
Holder for
mixing bucket
Transport handle
and support
Chassis
WARNING:
Do not use the support for the swivel arm as a handle for opening the device. It is only designed for depositing
the swivel arm on the floor when the device is opened.
Operational areas
The AutoMixx 50 L is used in particular for mixing a wide range of building materials in powder form, such as dry mortar,
plasters, fillers, adhesives and to mix liquid goods such as ready-made synthetic resins and silicon resin plasters, paints,
floor coating and 2K materials.
53
Handle for open-
ing and closing
the swivel arm
Protective grid
Mixer shaft
Safety screw
for swivel arm