Storch AutoMixx 50 l Mode D'emploi page 51

General safety instructions
WARNING:
Please read and observe all safety instructions and keep this manual for later use.
Work area
Keep the workplace clean and well ventilated. Cluttered worksites and dark areas provoke accidents.
Do not operate power tools in explosive environments, such as in the presence of flammable liquids, gases, or dust.
Power tools create sparks which can ignite dust or vapours.
Keep bystanders, children, and visitors away while operating a power tool.
Distractions can cause you to lose control.
Electrical Safety
This is a double insulated device. To preserve its insulation integrity, When servicing use only identical replacement parts.
Do not change the plug in any way.
Protection from electric shock due to electrical malfunction:
Avoid body contact with earthed surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of
electric shock if you touch an earthed surface. Do not expose to rain or moisture. Water entering the machine will increase
the risk of electric shock.
Only use the power cord for its intended purpose, never pull it to move the mixer, always pull the plug and not the cable
to unplug. Keep the cable clear of heat, oil, sharp edges or moving parts. Replace damaged power cords without delay.
Personal Safety
Take care when using the mixer. Failure to do so may lead to serious injury.
Wear suitable clothing. Do not wear loose clothing or jewellery. Contain long hair. Keep your hair, clothing, and gloves
away from moving parts.
Remove assembly tools from the tool before turning it on.
Use safety equipment. Always wear safety glasses. Respiratory masks and grip safety shoes should be worn, according
to requirements.
Mixer use and care
Do not overstrain the tool. Only use materials specified for use with the tool.
Any faulty switches should be replaced before the tool is used.
Never plug in the device before it is assembled. Unplug before setting the tool.
Store idle tools out of reach of children and other untrained persons.
Maintain tools with care. Keep the tool clean.
Always check the tool to ensure it is in sound condition and works properly.
WARNING:
CAUTION: Ensure that the correct voltage is supplied to the tool as specified on the type plate
51