TEFAL IH2018 Guide De L'utilisateur page 25

TE-PLAQUINDUCTION-NC00127885_Q7_final
• When the water reaches 100° C, the appliance emits 3 beeps
and stops heating.
• If you want to cancel boil mode, you can select another
program or press the on/off button.
• The timer function is not available for this mode.
except boiling water and heating milk
Cleaning
You must disconnect the power lead, wait until the ceramic glass plate has
cooled, then follow the instructions below to clean the appliance:
1. Ceramic glass plate: if the ceramic glass plate is very dirty, clean using a
damp non-abrasive sponge or for more stubborn stains use an appropriate
cleaning product which is designed for use on ceramic hobs.
2. Cooker body and control panel: Use a damp soft cloth to clean. In case of
any oil stains that are not easily removed, wipe away the stains with a soft
cloth rinsed in warm water and a little washing-up liquid and then clean using
a damp soft cloth.
3. Air entry/air exit surface: remove any dust with a cotton bud.
Timer function for all functions
• After setting the cooking parameters, press the timer button
(L) and the LCD screen will display the default time setting
(15 min). A beep sounds and the timer setting starts blinking
with a default time of 15 min.
• Press +/- button to set the cooking time ( 1-99min).
• For stew , after 60 min, the LCD shows « 1 H » and « 2 H »
for 1 and 2 hours
• After 3 seconds without any action the Timer starts and
LCD stops blinking.
• You can adjust the setting for the manual, fry and sauté
cooking programmes by pressing the +/- buttons.
• If you press a second time on the Timer button ,the LCD
starts blinking again and you can change setting with +/-.
• Once the timer goes below one minute, the countdown will
continue in seconds until the timer reaches 00, then the
hotplate will switch off and emit 3 beeps.
• To remove the Timer function, press the Timer button for 3
seconds.
25
12/9/14 11:37 Page 25
EN