Attaching The Plasma Display; Installing The Product On A Rack Etc - Pioneer PDK-TS14 Mode D'emploi

Attaching the Plasma Display

The weight of a 43 inch model is about 32 kg (70.4
lbs), they have no depth, and are unstable.
Therefore, at least two people must assemble and
Caution
install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Attachment Method
1
Attaching the Plasma Display to the stand.
Fit the stand's support columns to the bottom of the
Plasma Display as indicated by the arrows, then slowly
insert them vertically. Be extremely careful not to insert the
support columns of the stand into any part of the Plasma
Display other than the stand insertion slots. Note that doing
so might damage the Plasma Display panel or its ports or
result in the warping of the stand.

Installing the Product on a Rack etc.

Caution
When installing on a rack etc., hold the Plasma
Display.
4
En
Line up the column
supports with the bottom
of the Plasma Display as
indicated in the accompa-
nying diagram.
2
Securing the Plasma Display with
Installation bolts 2.
Attach the Plasma Display at the points indicated by the
arrows using the enclosed hexagonal wrench.
3
Securing the Plasma Display with
Installation bolts 3.
Secure them using the enclosed hexagonal wrench.
2
Installation bolts
(M8 x 60 mm: silver)
3
Installation bolts
(M8 x 30 mm: silver)