Tylo STELLA 2900 3000 Notice D'installation page 16

14
Fig. 11
Screw the upper cover washer into place, with the rubber.
Make sure the edge is flush with the edge of the inner sleeve.
Insert the black plastic tubes.
2.
Fig. 12
Press the mixer panel into place and position it at an angle.
Start with the lower edge (1.), then raise it up and press on
the upper edge so that it clicks into place (2.).
1.
2
Fig. 13
Lock the mixer panel. If the water temperature needs to
be calibrated, see the Service section in the user guide.
Fig. 14
Press the thermostat dial. Note: Make sure the arrows
point upwards.