Publicité
Les langues disponibles
Les langues disponibles
x 2
Fig. 3
Mount the column on the bracket. Be careful with the rubber button.
Make sure it goes right down into its lowest position. Remove the
plastic protector at the bottom. Make the column plumb and fix it
in place using the washer and screw. Tip: To secure the stainless
steel screw, push the supplied silicone tube onto the PH2 spanner
which holds the screw in place. Mind the cables. Fit the plastic
protector in the same place as before.
Fig. 4
Connect hot and cold water.
Blue marking = cold, Red marking = hot
Angle the left-hand connection point slightly towards the right.
Do not forget the fibre gaskets.
!
Fig. 5
If an overhead shower is to be installed, remove the end plug
and connect the hose. Do not forget the fibre gaskets.
11
Publicité
