Fig. 9
Lift up the front panel at the bottom and raise it upwards.
Gently place your foot at the lower edge of the panel to prevent
it slipping away. Make sure the steam pipe is in the centre.
3.
1.
4.
Fig. 10
Press the front panel in the middle (1.) so that it clicks into place,
keeping your foot at the bottom of the panel. Screw the lower
cover washer (without rubber) (2.) into place. Press (3.) and (4.)
so that it clicks into place. You may need to press hard. Check
that the whole front panel is fully inserted. The measurement
from the wall to the lower edge of the front glass panel should
be 100 mm.
13
2.