Télécharger Imprimer la page

Using Your Soclean 2 - SoClean 2 Guide D'utilisation

Système de désinfection de matériel ppc automatisé
Masquer les pouces Voir aussi pour 2:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

USING YOUR SOCLEAN 2

After set-up, using your SoClean 2 is extremely easy.
After following the connection procedure on page 14,
your SoClean 2 disinfects your PAP equipment daily.
Figure 6. Install Removable hose slot plug
WARNING: Do not physically alter the Hose detect
switches on your SoClean 2. Inspect the Hose detect
switches regularly for damage or inability to move up/down.
Failure of the Hose detect switch on your SoClean 2 may
result in the SoClean operating at an unexpected time.
1. Open the lid.
2. Install the Removable hose slot plug into one
open slot (Figure 6).
Orientate the Removable hose slot plug as shown in Figure
6. The round face of the Removable hose slot plug is on
the outside of the SoClean 2.
Note: Your mask and PAP hose can be inserted from
either side of the SoClean 2. To change sides, remove the
Removable hose slot plug by lifting it straight out, and
insert it into the slot on the opposite side.
22 | USING YOUR SOCLEAN 2
3. Remove outer plastic wrapper and blue tape from the
Cartridge filter and fully seat it into the Cartridge filter slot
at the back-right corner of the Disinfecting chamber.
4. Insert your mask into the Disinfecting chamber, allowing
its attached PAP hose to rest in the open hose slot,
opposite the Removable hose slot plug (Figure 7).
5. Close the lid with the PAP hose placed in the open slot
(Figure 8). The SoClean will now automatically operate
according to its preset time and duration.
Note: The SoClean won't operate without the mask
and hose present in the closed Disinfecting chamber.
Additionally, the SoClean will not operate if the Removable
hose slot plug is missing or improperly seated.
WARNING: Keep the SoClean lid closed until the green
status light illuminates (approximately two hours after
completion of the disinfecting cycle).
It is necessary to let the mask remain in the closed
Disinfecting chamber for at least two hours to ensure
that the ozone performs its disinfection function and
dissipates appropriately. After that period, the status light
shines green and the mask is ready to be removed from
the Disinfecting chamber.
Ozone quickly dissipates into the atmosphere. If you
accidentally interrupt the disinfecting cycle and release
ozone by opening the Disinfecting chamber lid, simply
step away from the SoClean 2 for 5 minutes to avoid
unintended exposure. Note: Your PAP equipment will not
be fully disinfected if you interrupt the disinfecting cycle;
therefore, it is recommended that you restart the cycle.

Publicité

loading