Cleaning And Storage - Cleanmaxx 02968 Mode D'emploi

and the operating time is extended by 5 minutes. After the process resumes, the
steaming still only takes 5 minutes, and not 8.
PLEASE NOTE: After switching to the pressing programme with steaming, the
steaming always starts again and lasts 8 minutes!
11. The device stops automatically after the set operating time has elapsed. The control
panel goes out and the device switches to stand-by mode.
If the operating time should be ended prematurely, press the
the process and the
erating time display (13). The control panel goes out and the device switches to
stand-by mode.
12. Remove the garment from the nylon balloon and hanger.
13. Pull the mains plug out of the plug socket and allow the device to cool down completely.
Tips
• If in the pressing programme without steaming hand-washed or non-machine-spun
laundry is to be pressed, allow it to dry fi rst.
• The pressing process without steaming takes around 10 minutes for a spun-
dried shirt. However, the length of time can vary depending on the material and thick-
ness of the material. We recommend that you start with a shorter time and extend it
if necessary.
• The pressing process with steaming takes around 15 minutes for a dry shirt. Here
too the time may vary depending on the material and thickness of the material.
• The nylon balloon for shirts and blouses can be enlarged or reduced in size with
the zips. For smaller sizes, the zips should be closed. For larger sizes, the zips should
be opened on both sides.
• Wide-apart buttons may result in the button strip crimping slightly during pressing.
Here it is advisable to smooth down the button strip again by hand immediately after
the pressing process.

Cleaning and Storage

PLEASE NOTE!
■ Do not use any caustic or abrasive cleaning agents or cleaning pads for cleaning.
These may damage the surface.
• Clean the device and the nylon balloon if necessary with a slightly damp cloth and a
little mild detergent if required. Then wipe with a dry cloth.
• Empty the water tank (5) if the device is not going to be used for a long time or before
storing it away. To do this, take the device apart and tilt the motor unit (6) so that the
water can escape from the steam outlet openings beneath the mounting fl ange (9).
• Allow all parts to dry completely before storing them away.
• Store the device in a clean, dry place which is protected from sunlight and is not
accessible to children and animals.
21
symbol until there is no longer any bar lit up on the op-
EN
symbol to pause