Cleaning And Storage; Troubleshooting - Cleanmaxx EL17001-00100 Mode D'emploi

Masquer les pouces Voir aussi pour EL17001-00100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cleaning and Storage

NOTE!
Before commencing the cleaning, note the safety instructions in the "Safety
Instructions" chapter!
Never immerse the device, the mains cable or the mains plug in water or other liquids!
Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the
device. These can damage the surface.
Clean the device and the nylon balloon if necessary with a slightly damp cloth and a
little mild detergent if required. Then wipe down fully with a dry cloth.
Allow all parts to dry completely before you put them away.
Store the device in a clean, dry place that is protected from sunlight and is not acces-
sible to children and animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work. The LEDs do
not light up.
Unusual noises
The device switches
off suddenly.
Odour produced
00384_DE-EN-FR-NL_A5_V4.indb 17
00384_DE-EN-FR-NL_A5_V4.indb 17
17
Possible cause / solution
Is the mains plug inserted in the plug socket correctly? Cor-
rect the fi t of the mains plug.
Is the plug socket defective? Try another plug socket.
Check the fuse of the mains connection.
Is the device switched on? Set the timer (7) to a time.
Are the ventilation slots (6) covered up or blocked? Free up
the ventilation slots (6).
Are the ventilation slots (6) covered up or blocked? Free up
the ventilation slots (6).
The device has an automatic safety switch-off function. It
switches off automatically if it overheats. Allow the device
to cool down and switch it on again.
Has the device fallen over? The device has a protective
switch that is activated if the device falls over. Set the de-
vice up again and switch it back on.
Has the set time elapsed? Set the timer (7) to the time you
want again.
You might notice a slight odour caused by production res-
idues the fi rst time you use the device. However, this is
harmless and will cease as you use the device.
EN
07.12.2017 08:57:53
07.12.2017 08:57:53

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

00384

Table des Matières