Cleanmaxx 02968 Mode D'emploi page 20

EN
5. Spread the clamps along the bottom of the garment (at the front and back in each
case on the outsides and in the middle on the button strip at the front) so that it is
weighed down and will not go out of shape when the nylon balloon is infl ated.
6. Insert the mains plug into an easily accessible plug socket. The device switches on
and on the control panel (8) the symbols
7. Select the programme you want by touching the appropriate symbol on the control
panel:
– pressing programme without steaming (intended for damp textiles)
– pressing programme with steaming (intended for dry textiles)
On the control panel, the symbol for the programme you want and the arrow symbols
(14 + 17) light up. The symbol
8. Use the arrow symbols to set the operating time you want (max. 30 minutes). 1 bar
represents 1 minute of operating time here.
When setting the time for the pressing programme with steaming, please note
that the process of steaming the garment takes approx. 8 minutes and only then
does the pressing process start. An operating time of approx. 12 – 15 minutes
should therefore be set.
9. Touch the
symbol for the set programme fl ashes.
The lighting of the control panel switches off after approx. 40 seconds.
To reactivate it, touch the middle of the control panel.
10. Once the nylon balloon has infl ated, straighten out the garment and smooth it down
again.
The pressing process can be paused at any time by touching the
When the process is interrupted, the
If the operating time for the pressing process is to be adapted, use the
symbols to extend or shorten the operating time. Then touch the
to continue the pressing process.
If during the pressing programme with steaming the operating time is adapted,
this change only affects the pressing process and not the steaming! Example:
The operating time is set to 15 minutes. The process is interrupted after 3 minutes
4. Pull the garment which is to be pressed over the nylon
balloon and the hanger (1) and do up the buttons if neces-
sary. Make sure that
– the collar is fi tted over the collar section (12) on the
hanger,
– any button strip is over the hole line on the nylon balloon,
– the arms of the nylon balloon fi t properly in the sleeves
of the garment and are not twisted or scrunched up,
– all buttons on the garment (including on the sleeves) are
done up.
(16) fl ashes.
symbol to start the pressing process. It is now permanently lit. The
20
(18) and (15) light up.
symbol fl ashes.
symbol.
and
symbol again